Tip:
Highlight text to annotate it
X
Ok, we're just wrapping up here at Lewis Chevrolet Cadillac in Garden City, Kansas.
And...this is how it turned out.
Up here, we built a wall...you can see it up their.
Down here, you can see this is all parts.
This is like the main busy intersection, so, it has definitely been a challenge just getting
through here and getting up.
I'm going to walk up the steps, and I'll show you what it looks like up here.
There again is the wall. You can see where it's attached to the ceiling.
We're also attached to the floor, and, uh...we put plywood and pegboard on it.
And you come into the tool room.
Over here, we have eleven panels...full-size panels.
And we put a piece of peg board right here that they can utilize for tools if they need to.
And then you come down here, and we have these custom panels. And we have seven custom panels.
We had to cut them off because we had a duct down on the bottom.
You can see, we...we made them a short, uh...a foot shorter.
We put peg board back here that they can also add tools.
They have room for growth on the backside of that board, on the very end.
You can see how it came out.
It's a nice tool room.
A little tighter then we like down through here right now, but they are going to move
that shelf back their and then this can go back a little further.
There's all their kits, they are all labeled.
If it's an essential kit there will be a tag on the board referring back to it.
Here's another shelf...we put their engine stand stuff down their in them two blue totes.
We put fixtures...got some of their tubes hanging here.
Up their, that's just miscellaneous hardware and stuff.
That shows ya...we put plywood down on the floor here for working up on this mezzanine.
Over in here, we've got six boxes of the older recommended tools, broke down in numerical
sequences.
And that top box their is extra supplies.
Over in here are the latest, or the, the newest non-current tools that we always keep around.
That's a high voltage box on top their.
Come over in this room.
This is the room that we inventoried in.
And there is all the non-current tools that we've taken out of here.
There were eleven boxes of stuff that were taken out of here.
And there is still some non-current kits downstairs that they're gonna go through and just get
out of the building.
But, this is how it turned out.
We worked for Jordan over here. We worked in Adams parts department.
They are some awesome guys.
We had Cory help us, Jeff help us a little.
And, uh...with that...and we worked with Mike.
Awesome guys, real nice guys.
They treated us really good, and showed us hospitality out here in Kansas.
And with that, we're going to thank Tool Org. for the job and we're going to thank God for
His help as always.