Tip:
Highlight text to annotate it
X
hello in this tutorial I show you how to make a flat knot bracelet
Material
hemp yarn of the color you want, ruler, scissors and a safety pin
first take the thread and measure a piece of 200 cm and cut
then measure a piece of 60 cm and cut
leave the thread, ruler and scissors
take the tips and pair them
join the tips and make a knot
hold the bracelet
separate de threads, the short threads must be in the middle and the long threads in the sides
hold the middle threads with tape
take the left side and put it over the 2 threads in the middle making this figure
take the right thread, put it over
take the tip and pass under the middle threads like this and through the gap
pull and tighten the knot
do the same on the other side
take the right thread and put it over the middle thread making this figure
take the left thread, pass it over
take the tip, pass under and through the middle
tighten but don´t too hard, it has to be with the same strenght on both threads
here it goes again
pass the left thread over the middle threads making this figure
take the right thread and put it over
also take the tip and pass under and through the gap
pull and tighten up
do the same on the other side
I´ll give you a tip, when you leave the bracelet incomplete and want to continue
as you are tying, these lines are becoming depending the side of the straight thread
this line was done with this thread
if you braid the line would be in this side
here is the line
use this tip when you don´t knot how to continue
continue braiding until you reach the desire length
when you finish, remove the tape and make a knot
tie well and cut the excess of thread
you finished
I hope you enjoyed this tutorial, remember to subscribe
leave comments and share this video with your friends