Tip:
Highlight text to annotate it
X
I’m Chris Tavano for Tundra Restaurant Supply.
In today’s episode I’m going to show you
How to change the blades and blade assembly to your Nemco Easy Chopper II.
The first thing you’re going to want to do
Is remove your pusher block and your base assembly base.
Two little bushings just slide right off the greased poles
And your blade assembly should slide right off as is.
First and foremost this is your blade assembly faced up.
Be very careful as these blades facing up are very, very sharp.
I’m going to want to turn it upside down exposing the bolts.
Get your crescent wrench and we’re going to loosen these all the way off.
Once you’ve unscrewed your bolts
The base plate should come right off.
Set that aside
And now you’ve exposed the bottom side of your blades.
This is going to be how we’re going to replace these.
These metal bars, those are going to stay.
Do not throw those away.
An easy way to get rid of your blades,
Flip it upside down,
Give it a little tap.
Your entire blade assembly comes out.
The first thing you’re going to want to note
When you open your package of new blades
Is that there are two different kinds.
Some are going to be loaded first
And some are going to be loaded second.
The best way to tell is identify where the slit is on the blade.
If you notice both these blades are facing the sharp edge towards you
And this front row has slits towards the back base of that blade.
Whereas the second one has the slits going through the cutting edge of that blade.
We’re going to want to put in these ones first
Where you see the slit coming from the back.
From here you’re going to want to organize your spacer guides.
If you notice these little bars that we kept from the original,
There’s little slits.
You’re going to want to see the slit
That goes all the way through the wall of that guide
To be facing the inside of the assembly.
Place all four of those around the perimeter of the assembly itself
And from there we can get our first set of blades
Where there is no slit on the cutting edge itself.
Being very careful with these blades,
You’re going to put blade down in the first slit
Horizontally in your spacer guide
And the next one.
Being sure to be very careful
Putting the cutting edge of each blade down into the spacer guide slits.
So after you’ve got your first set down
We’ll work on the second set of blades
Where the slit goes through the actual beveled cutting edge itself.
And these blades we’re going to place perpendicular
Going through each and every slit on the previous blades that we set in,
As well as the spacer guide itself.
Be sure that you’re pushing down with enough pressure on these blades
To where all the tops are even and flush.
Don’t have to worry too much on this side
Because remember you’re putting the cutting edge of the blade down into your table.
These edges are not sharp.
As we put our base plate back onto our blade assembly,
Be sure to line up the post holes accordingly on your base.
Screw your nuts back in, righty-tighty.
Now remember when you flip this over you’re going to have brand new sharp blades
So do not touch that surface up there.
Once you’re replaced the blades on your blade assembly,
It’s just a matter of getting this block back on the base of your chopper stand.
Keep in mind that these top blades are very sharp to the touch
And these elongated holes are for your post slots.
You’re going to grab your bushings next;
Slide those on.
If this is getting a little stuck
Just add a little bit more food grade lubricant or grease to these posts.
Then you’ve got your pusher block back on.
That’s how you replace the blades in a blade assembly
For your Nemco Easy Chopper II.
Here’s to a better mise en place!