Tip:
Highlight text to annotate it
X
I cut veneer strips for the inner surfaces of the inner part. But I also use veneer of sycamore.
For this veneer is also the package for the book pages.
At this point I have to report something first.
I got off to a classic false start.
I have made ??reference to my sketch and dimensions but then not seen it.
I saw the part 29 centimeters from, but that is the outer dimension of the book, the inner part is much smaller.
That was the first mistake.
The second mistake. I glues mahogany veneer on the interior surfaces.
When I glued it, I think it should but inside all look the same.
Conclusion. I remove the veneer back and glues on Sycamore.
The bone glue makes this possible.
For this I need to show them something. Get quick.
The package veneer I can not glue them in one operation.
I was going to make me simple and use carpenter's glue, so I have more time to work.
But no! I take a lot of time for all other work and so I will use glue here too the bone.
Now very briefly. Who has not seen it yet.
Here the part. A wet towel on it and a hot iron.
OOOh no! It continues with the margins. 1 minute to the iron is hot.
So it was not thought that I you-sufficient with a series of mishaps.
The water vapor kan only down penetrates through the pores of the veneer and dissolves the glue.
Often I can then pull down the veneer or I have to take the spatula.
I promise improvement.
Here we go, the strips are glued.
I've done everything warm. This is a hot plate from the restaurant.
Moistening to allow the veneer to bend against the wood.
Rub on now. Through the cold hammer and the glue is cold and sticks immediately.
The parts are all veneered and plastered.
Now I glues the frame together.
I want my grandson, Amon imagine. He is most dear to me in the workshop.
warming
I have been waiting for the opportunity to introduce my grandson here.
Now just measure it, the dimensions match.