Tip:
Highlight text to annotate it
X
This video is to show how to get your Tomet on your car window
The first step is to clean your windows. Any dirt or dust may cause
air bubbles that you can't remove. Remove the Tomet from its packaging.
In this case it's a Basketball Tomet.
Inside you will find
stuck to the packaging, a sticker which has three layers:
the rear layer is blue,
the middle layer is the sticker itself,
the upper layer is a transparent transfer sheet.
The next step is to remove the sticker from the blue backing
The tab that is left on the packaging can be used to do this.
The third step is to position the sticker with the
number in the lower left hand corner
and gently press down the opposite sides.
The fourth step is to lift up half of the transfer sheet with the sticker attached
and firm down with a card to remove the air bubbles.
Keep working towards the outside to remove the bubbles.
. Remember: don't firm down completely
until you are happy with the result.
The fifth step is to do the same to the other side. Firm down with a card to remove the air bubbles
So long as you keep the transfer sheet
attached to the sticker and don't firm down completely
you can keep lifting up and pressing down the sticker
again and again to remove the air bubbles.
The transfer sheet helps the application,
it also stops the sticker from getting scratched
by firming down with the card.
The sixth step is to carefully remove the
transfer sheet on an angle so that the sticker stays behind.
And there you have it. Tomet applied - no air bubbles.