Tip:
Highlight text to annotate it
X
Hi, this video is about an atomizer for direct dripping on the coil – K6.
K6 is hiding in this little paper box,
here it is.
The top is aluminium, with a 510 driptip,
there´s also a rubber ring
which you can hold and detach the atomizer from its base.
The bottom is threaded.
Here the heating system is hiding,
here is the sealing, so there is no chance of leakage.
It is possible to change the heating system,
either recoil or buy the whole new setup.
You can turn the little screws just with your fingers, it is possible.
Air intake is secured by a little tube under the coil
which brings the air from the bottom part of the atomizer directly to the coil.
The wicks supply liquid to the coil, of course.
With 510 thread.
Before the first use we can try to burn it out a bit.
The coil is heating nicely, evenly.
Resistance 1,8 ohm.
We can put some liquid directly on the wicks
and then just put the upper cap like this,
screw in, and we are ready to vape.
Let´s do the measuring:
diameter in the widest spot 19 mm,
length without a drip tip/thread 28,3 mm,
with an original drip tip 47,3 mm,
weight 27 g.
Let´s just drip a bit more…
The resistance again – 1,7 ohm,
it changed when soaked up with liquid.
I will use 9 W.
Not bad.
Of course, this is a wick system, for wick systems fans.
So, this is a wick rebuildable atomizer,
designed for direct dripping on the coil – K6.
That´s all from me now and see you again soon at some of my videos.
For Gold Drive prepared by Vorel Vaping Film´s.