Tip:
Highlight text to annotate it
X
Hi, it’s Steve from PartSelect. Today we’re going to show you how to change the inner
cap seal on your agitator. Really easy job; no tools required. Let me show you how it’s
done.
Now to replace the inner cap seal we simply need to remove the cap off the agitator or
the fabric softener dispenser if it is so equipped, it should just pull out. That will
expose the barrier cap and seal and there’s two tabs on that so we can grab it and pull
upwards on it.
Remove the barrier and the seal. The seal goes around the barrier in a groove around
it; sometimes it will come out in one piece and sometimes two pieces. Simply remove the
old seal, discard it.
Clean any debris that may be in that groove. Roll the new seal into place, make sure it’s
sitting firmly in there; you may want to moisten that or put some dish detergent to assist
in reinstalling it, and simply slide it back into the agitator, keeping it level, snap
it into place. Make sure it’s firmly seated, just give it a little tug on those tabs to
make sure that you have it in properly, replace the fabric softener dispenser, and our repair
is complete.
That’s how easy it is to change the cap seal on your washer. Thanks for watching,
and good luck with your repair.