Tip:
Highlight text to annotate it
X
This is Jon on behalf of Expert Village in this video clip we'll be cutting out our legs
first we're going to take off that first 2" (cutting) next we're going to cut at our 48"
mark (cutting) and next we're going to cut out our second set of legs (cutting) After
that we're going to take it over to the joiner and clean out one edge,
next I set my table saw to 4 1/32" and I'm going to rip each of my legs (cutting) now
before I rip the second leg from each board I'm going to run it through the joiner again
just to clean up that edge.
And then I'm going to rip my other 2 legs,
once all 4 of my legs have been ripped I need to take off that 32 second and clean up that
cut edge on the joiner.