Tip:
Highlight text to annotate it
X
Hello everyone, here is a short video demonstration of Tanaka Luger P08 Heavy Weight version.
When you receive it, it is like that, but if you want to insert a magazine in, it doesn’t pass.
And if you force, a small part inside will break.
Before, we must ***, and then insert the magazine, and after you *** again to shoot.
We'll put a few BB’s to test.
I reduced the capacity to 8 BB’s : now the spring is more powerful, it was very low at the origin, and the bolt catch works every time.
I *** and now we can shoot.
Oops ... sorry ...
That's it.
So there, the bolt catch works. We can also note a similarity with a Star Wars starship.
We can see that on the side, we have a safety, and we can’t shoot anymore.
For removal the upper part and access to the hop-up : put off the magazine, make sure the gun is empty, slightly pushing the barrel, pulling the small pin in order to release the part.
The hop-up is a small screw here.
To replace, it's the same thing in reverse by pressing the lever here. It puts the little piece correctly, you push back slightly to return the lever.
About the magazine, it was a big problem concerning the seal. I have two magazines, and both had the same problem, you must remove the magazine and put the butt of joint compound around the seal inside. We assemble again, put the small pin, we wait for the drying and pray that it works!
Well, I hope you enjoyed this little video, you can join my Facebook page "Neo035" and if you like this video, tell it me!