Tip:
Highlight text to annotate it
X
Hello. Welcome to the video where we will introduce
another rebuildable atomizer of Genesis system called I-Atty.
So, let´s have a look...
A tube box,
accessories, little screwdriver, sealing kit,
mesh, little resistance wire plaite – this is the accessories included.
And I-Atty itself.
Let´s measure it first:
without a driptip almost 49mm,
with a driptip 68.5mm,
including the thread 73.2mm,
diameter almost 21mm, and inside diameter 19mm.
Weight 74g.
So, it is a classic Genesis system,
removable 510 driptip, upper cap over the two o-rings,
mesh, resistance wire,
one resistance wire contact, center pin, the second contact.
Let´s go totally inside:
first we will remove this little screw,
the second screw of the coil – by the way
this little screw is of course used for filling,
we can remove the heating system,
the nut – it has no threading but it is surrounding the center pin,
we can also push the center pin out, and now just simply unscrew what is left,
everywhere you can see the rubber sealing so it feels kind of tough,
the thread here which fits here in the center contact stick – it can also be unscrewed like this,
there is silicone sealing...
Well....and that´s it....
Simple Genesis system.
So, we put on this clear tube, carefully the upper part....
softly, we can stick in the center pin,
now this little piece,
heating system – which you can prepare according to your preferences
or like me....you can use this setup ready made by our Chinese friends,
this upper little screw is nicely big so it is easy to work with it.
So, now it is ready...
....and we can check how it heats...it has some 0.9 ohm.
Well, that´s it, we are ready.
Now, we just need to fill in some liquid and start vaping.
Again, be careful with the air hole, put it directly opposite the coil.
I-Atty is filled, checked... what should I say about that...
Mesh doesn´t have a hole in the middle
so you cannot use a needle for filling as I am used to – so this I would adjust.
Resistance wire was not tighten enough on mesh...so it basically was heating in the air...
It is a Chinese setup so you shouldn´t expect something extra,
however it works if you give it what it needs.
So, filling - I am used to do it with a needle through mesh or this little screw...
Filled, air hole opposite the coil,
mechanical mod because it has 0.9 ohm so on standard electronics you can´t use it.
Well...and let´s vape...
Like almost any Genesis system...
It wants what it wants, and that´s why there are discussions about these products
where you can find various settings, various setups...and you can follow these or you can figure out the setup of your own.
Have a nice day, enjoy your I-Atty and see you again soon.
Bye.