Tip:
Highlight text to annotate it
X
[OEM Audio Plus intro music]
Using a Panel or Pick tool disengage door locking tab.
Remove the small screw cover behind the interior door latch.
It is best to remove this piece and set it aside to avoid falling off and being misplaced.
Remove the number two Phillips screw behind the door latch.
Remove silver trim from the door grab handle.
Tool insertion slot is located at the bottom of the trim.
Remove the two number two Phillips screws securing the grab handle.
Using your hands or a panel tool, disengage the clips behind the door panel one at a time.
Start at the bottom, then the sides and finish at the top.
Use gentle force to remove door panel.
Disconnect window/door lock control connectors from door panel.
Use pick tool to apply pressure to lock in tab of connector this is necessary to remove
the connector properly.
Remove door latch assembly from the door panel by unsnapping and lifting the door latch connectors.
Connectors need to be reassembled in the same orientation.
White on top. Green on bottom.
Set Door panel aside.
Removing the Factory Speakers.
Disconnect the six and a half speaker connector.
Remove the three number two Phillips screws holding the factory six and a half inch speaker
in place and remove speaker.
Mount the six and a half inch OEM Audio Plus speaker by using the three number two Phillips
Screws and re-install speaker connector.
Reassemble door in reverse order - Taking time to ensure all engaging all clips.
Failure to securely reinstall door panel may result in rattles.
This concludes the installation of the oem audio plus reference series upgrade.
[FRS BRZ outro music]