Tip:
Highlight text to annotate it
X
The Pro Touchoff Gage by Edge Technology is a must have accessory for any CNC milling
machine. It is designed to quickly and accurately acquire your tool offsets. This gage will
dramatically decrease setup time and eliminate tool path mismatch, ensuring every job is
setup the same way and runs without issue.
When we say dramatically reduce setup time, we mean it. This clip shows four tools being
perfectly set in under a minute. To use this gage just lower the tool down on to the contact
face until the indicator reads zero. At that point you can be confident the tool tip is
exactly four inches from the surface the Pro Touchoff Gage is sitting on.
The large indicator face can easily be read from outside the machine. It also allows you
to see tool movements as small as one ten-thousands of an inch, guaranteeing that your tools will
be set perfectly every time.
It is typical for cutting tools to have slight variations in flute length. To compensate
for this issue the Pro Touchoff gage has a large one inch contact face that allows all
of the tool flutes to contact the gage at the same time. This method automatically sets
the tool from its longest flute.
The rectangular base and recessed indicator face of the Pro Touchoff Gage is designed
to work well with any parallel bar setup.
With an offset height of exactly four inches, the Pro Touchoff Gage can easily be calibrated
using a few one-two-three blocks.
With the affordable cost of the Pro Touchoff Gage, it is easy to justify the upgrade from
shimstock, paper, gageblocks or other inferior techniques that are currently being used to
set tools. If you want to spend less time on setup and more time cutting chips visit
us at edgetechnologyproducts.com and pick up yours
today.