Tip:
Highlight text to annotate it
X
So now go ahead and take your strip of bicycle inner tube and wrap your ring. Just start
in a little spiral. You might want to start on the weld there, if it's, if any little
thick anywhere, it's o.k. if it's thick there. You don't want to overlap it too many times
so you got to pull it fairly tight. Oop, there was the blow out there. So if you go around
like more then if you, if you wrap it on itself more than once it's just going to make your
ring thick. You don't really want to make your ring so much thicker then they might
have trouble fitting on your drum. You're definitely taking under that how tight your
rings fit and accommodate for that. Your rings are a little tight and your worried then make
sure you don't over lap it too much.
So this is a really big ring so once you get to the end just it, cut that end and tape
it. Just with electrical tape works fine and you're not going to see this ring so it doesn't
matter what it looks like.