Tip:
Highlight text to annotate it
X
This video will show you how to install an Evolution Series Floor Box into a raised or
wood floor, so you can begin to bring large quantities of power, communications, and audio/video
devices into any open-space application. The tools you'll need to complete the installation
are: a drill, both a Phillips and a flathead screwdriver, a hammer, lyman pliers, electrical
tape, 8 30 second nut driver, an adjustable wrench, and a tape measure. To start, position
the floor box in accordance with your job site floor plans or your engineering blue
print. Determine the wiring path of your box and remove the appropriate knockouts. Mark
and cut a hole in the wood floor or raised floor panels based on the dimensions needed.
Measure the hole to make sure the box will fit properly. The hole should by 15 3/8" by
11 9/16". Next, remove the cover by unscrewing the 4 screws and lifting the cover off the
boss. Remove the modules by unscrewing the screws that secures the modules to the base
of the box. Lower the box into the hole cut on the floor. At the front and back sides
of the box are adjustable toggle clamps that are used to secure the box to the floor. The
clamps are positioned to allow for up to 1 and a half inch thick floors. Tighten the
clamps so that the box is held securely to the floor. Remove the knockouts from the plates
with the device modules and attach the appropriate cable fittings to the plates with the modules.
Cable fittings are sold separately. Attach devices to mounting brackets using the fasteners
provided with the devices, and reattach the backplate to the module using the screws provided.
Attach flexible cabling and terminate to appropriate devices. Now, you'll be ready to reinstall
the module into the box. Reinstall modules into the box by placing them in and twisting
upward. Replace the screw provided to fasten the module to the base of the box. Next, attach
the wire guides to the sides of the box. Reattach the protective cover until you're ready to
install the finish cover. Complete your installation by attaching an Evolution Series Floor Box
cover (sold separately) with the instructions supplied with the cover. That completes your
installation of the Evolution Series Floor Box. Your box is now ready to supply power,
communications, or A/V wherever it is needed. One box, works everywhere, changes everything.
Legrand -- designed to be better.™