Tip:
Highlight text to annotate it
X
Hi I'm Justin with AmericanMuscle.com, and I'm taking a closer look at the SR Performance
Caster/Camber plates, fitting all 94-04 Mustangs. If you're thinking about lowering your car,
then your alignment might be a potential issue, depending on how low you go, you may not be
able to get your car back into factory specs, without the help of something like these plates
from SR Performance. This kit allows you to properly dial in both your Camber and your
Caster, which are two of the biggest areas that get affected whenever you lower your
car. Without addressing this, your car will not only handle poorly, but you'll also chew
through tires much faster due to improper wear. Taking a closer look at the plates themselves
you'll immediately notice the quality construction, these plates have been CNC'd from a single
block of Billet aluminum for superior strength, and although not quite as important, they've
also been finished off with a very attractive satin finish, which is sure to look sharp
under the hood. The install is a little time consuming and will involve you pulling the
strut arm down the get the strut out of the strut tower. Although this can be done using
some basic tools and a floor jack, expect to spend about 3-4 hours completing the job.
So if you're looking for an affordable way to get your alignment back in check after
lowering your car, then you'll want to check out SR Performance Caster/Camber plates, available
right here at AmericanMuscle.com