Tip:
Highlight text to annotate it
X
Go to Beadaholique.com for all of your beading supplies needs!
Hi. This is Julie with Beadaholique.com. Today we're going to do a product demo of the Mirco-Flame
Torch.
This is great for using in various jewelry projects including resin making when you want
to get the bubbles out, soldering, jewelry casting
wax working, metal sculpting and a whole bunch of other applications.
So first off when you get the torch you're gonna need to fill it.
To fill it we're going to just use
a butane canister.
And we've got this just at the local drugstore so you can find it in multiple places. Your
grocery store might have it, it not a hardware store surely would.
So to fill the Micro Torch what we're going to do
is we are going to take
the canister
and we're going to hold the Micro Flame
upside down.
There's a little area right here with where this nozzle is going to go right into.
We're going to
fit that over
and we're going to press down.
You're going to hear a little bit of a hissing sound
and that is
the butane going into the torch.
When it squirts out like that, that means it's full.
You don't need to seal it off or anything.
Now if you're not filling the torch for the first time and you've used it before and it's going to be
a refill, make sure your torch is off
before it you fill it.
Our torches here that we sell at Beadaholique.com come with a nice little stand.
So you could just put that aside until you're ready to use it again.
Now when you want to go ahead and use it what we're first going to do
is we are gonna slide this little tab right here so it's in the middle to where it says gas
and then we're gonna rotate
the air adjustment ring. You can see in here that there's little holes.
What we want to do is to make sure that those holes are halfway covered and
and this is going to adjust your flame later on. It's good to start at the halfway mark.
To start your torch what you're going to do is pull down the safety switch.
You can see right here. I'm gonna pull it down with my thumb. You hear it click into place.
Now this is the ignition button. So when I want to start my flame, I push the ignition button in.
You can see my flame. If I release it
the flame goes away. So to restart it
go ahead
pull that button down.
Hit the ignition switch and then if you want to continous flame
you push that button right there and it's going to hold the flame for you.
Now you can use this for your projects.
To turn off the flame
you just go ahead
and hit that ignition switch again
and it releases and your torch is now off and you can set it aside
for future use.
Go to Beadaholique.com for all of your beading supplies needs!