Tip:
Highlight text to annotate it
X
Next, we're going to set the door like this, and then we're looking at the bottom of the
door. This is the general area, where it appears to be hitting, so we're going to take our
plane, and we're going to take off some material. Now, you can adjust how much bite, the plane
takes out each time. You see the blade is just barely sticking out. That's a sharp blade,
but that's not much. To adjust, here's the adjusting ***, and you can take off more,
if you drive it in, and less if you pull it back. So I'm going to have this braced up
against here, and move it back a little bit, and we're going to, oops. Boy, that seems
to be a lot. I'm going to take some off of that, and adjust that back a little bit. Let's
try that now. Now, we're taking off smaller amounts, off of the end of the door. Yeah,
that's not much. I'm going to have to take off a little bit more than that, so I'm going
to readjust the file, the plane. Here we go. Oh yeah, that's definitely more. I can feel
it flying out of here. It's not much, but the difficult part is right here at the end,
where I'm hitting on the end of this grain. So what I want to do, is hold the plane, so
that it's even with the whole door, and then I'm going to work it like this, trying to
keep it level.