Tip:
Highlight text to annotate it
X
this video will demonstrate how to retrofit
a MinXray HF 120 power plus x-ray unit
into a fully functioning direct radiography system
there are four components to the NDRK 2 upgrade kit
they are the lower electrical control box
the upper IP storage tower
Dell FXR 6400 laptop
and the very an IP panel the only tool needed for the upgrade is a standard
Phillips head screwdriver
begin the upgrade simply by lowering the front legs of the XGS stand
and raise the tube head then remove the exposures which with cable and power
cord
from the MinXray HF 120 x-ray unit
unscrew the phillips head clamp screw
and lightly open the frame mounting clamps and remove shipping spacers from
the clamp
attached to the back of the lower electrical control box
set the lower electrical control box in the cassette storage rack
on the MinXray HF 120 XGS stand
secure the two mounting clamps around the stand frame with the Philips head
screw provided
next slightly open the two frame mounting clamps on the upper IP storage tower
and remove shipping spacers from the clamp align the pin and socket bidding
on the bottom of the upper IP storage container
with the pin and socket fitting on the top of the lower electrical control box
and seat the upper IP storage tower
one pin and socket fittings are seated secure the two frame clamps on the back
of the upper container
to the frame of the MinXray HF120
with the Phillips head screws provided in the clamps there will be five cable
bundles
exiting out at the top of the lower electrical control box
computer connection bundle IP panel connection cord
exposure cord with switch x-ray tube head communication bundle
and electrical power cord
secure IP plate and storage tower with handle out
and cord exiting out at the top when not in use
connect the very end IP plate using the Quick Connect panel connection cord
by aligning the two red dots on Quick Connect fitting
and lock into place secure the Dell
XFR laptop to the laptop tray on the upper I P storage tower
connect computer connection bundle into the computer power outlet
and connect the rj-45 connector
into the Ethernet port on laptop connect the two head communication bundle cord
into the power port and the rj-11 port