Tip:
Highlight text to annotate it
X
in Prlolink
I go to File
hence I create a new project
in this case I will create a folder new , to record
this new project
hence I click on save
again , on file , I'll click on Send Recive
or the icon in the menu bar
I hope to open a window , striking to connect
hence , in settings
I will select the port and Data transmission speed
in this case I am using a cable USB transmission
to pass data from the station
a computer
Always make sure that the cable is securely connected .
in the total station , I must ensure that the transmission facings
are the same as in Prolink
I'll Memory , JOB ,
Comms Setup
there I will set the baud rate as
prolink in this case was 9600
bps
Otherwise I will leave
as is . After this select the destination folder
select the device icon
pulse and the arrow pointing left, leaves a window
step to the total station will Memory , JOB , Comms Output
and I select the job I want
transmit to the PC
I press Enter, then OK
or F4
SDR33 select and pulse : Enter
I will select
observed data
then begins transmission data
synchronized in prolinkand and
in the total station
once the procedure is completed
I will to Prolink
close the window
I will to file
and then
Import
SDR select from the list of formats file
Seeking folder
destination
which was created early
I select the file sdr
and pulse accept.
Here you can already see the data
go to menu , hence I put in Export, I select the file format that
I want to export
in this case DXF
I select the target folder , file named
pulse accept
Selected again : export
to view the file
and open it directly
from this window
now you can see
in Autocad
thumb up, and subscribe