Tip:
Highlight text to annotate it
X
So here we have the other board that's a gloss and polish. We've had this out here for, you
know, about 45 minutes to an hour. The resins really hard and you can barely put your nail
in it. That's a good test, just run your fingernail in it and if it doesn't show anything that's
pretty much ready to go. So we'll take that out and we're going to polish this and finish
this board as well. So now we have it on the sanding rack. What we're going to do is grab
some 220 paper and we're going to start off this and ending with the 220. We'll take the
edge down with the 220 and then we'll go ahead and run it back and forth after that with
the 320 and get those scratches out. Take off the 220, I got some 320 over here. This
is just a nice wet sandpaper, take out the 220 scratches and then that way when we buff
out that resin it's just going to get really shiny, you're not going to see any scratches
in it. That's what happens when there's no glue on it. Just apply some more glue, get
that paper stuck back on there, just like that. Alright, it should be ready, let's go.