Tip:
Highlight text to annotate it
X
Today in this 2010 Kia Sedona were going to install part number c13345 from Curt. Alright
this is what the hitch looks like once installed on the vehicle. Next well give you some measurements
that will help you out in selecting some accessories. From the center of the hitch pin opening to
the edge of bumper were looking at five and three quarter inches and from the top to the
receiver opening down to the ground is 11 inches. No well go ahead on how the hitches
installed and the hitches install some frame here, here and here. Let me just thread a
holes on the frame but we need some time up to clean.
Were going to spray it with some lubricant and then take some of the hitch bolts and
run it in first to make sure we get all the dirt and debris out. The older the vehicle
is the more dust going to collect in there and you have to work harder at you might have
to use a toothbrush or waste case scenario after a few years you might have to use a
thread tap next were going to lower the exhaust on the passenger side now it gives us more
flexibility to install our hardware. Now we can go ahead and install our hitch well take
the passenger side of the hitch and put that on the exhaust let that hold up that side
while we install the hardware on the driver side. Driver sides lucent installed lets go
to the passenger side repeat the same process with all the hardware install we go ahead
and snug down the bolt. Then we tort them down as best said in
the instruction.