Tip:
Highlight text to annotate it
X
Okay, we went ahead and cut the batting off the edge. Now we're going to go ahead and
flip it. Just reach your fingers in here and grab a far corner and very carefully turn
it inside out. Now with this being satin, you have to be that much more careful. If
you're noticing too much pressure, having too hard a time getting it to come out, it's
a good idea to go ahead and cut a couple extra stitches. You can do just like that and that
way it doesn't rip your material. If you do rip your material right along the edges, you
can probably tuck it in when you hand stitch it if you need to. Once you have it all the
way out, you're going to want to get your needle and thread ready so we can stitch the
hole closed, just like so. Just give it a good shake out. It should be something like
that. Then you'll have your edge which you're going to want to stitch. And mine did not
line up perfectly because I didn't have it pinned quite tight enough. So, I'll have a
little wrinkle in there. And if you're feeling too picky you can go ahead and take them all
out. I know my little cousin, Evie, is not going to mind so I'm going to leave it like
that. I'm going to go ahead and pin it so the insides are in. Try to get it as even
as I can. I have my needle and thread ready, tie a good knot on the end, start stitching
from the inside so that your knot is hidden. And you're going to do -- I believe it's called
-- the whip stitch. Just keep going around the outside.