Tip:
Highlight text to annotate it
X
Hi, this is Jon, and in this clip we'll be creating the handle. The last piece that we
need to create is the handle, and that is going to be 1 1/2 inches by 20 inches, and
we only need one of those. The handle is going to be going on the top of our project, from
outside to outside. First I'm just going to set my table saw to 1 1/2 inches, and run
my board through.
Next I need to measure 20 inches on my board. And go ahead and cut it to that measurement.
Next I'm just going to double check that my measurements were correct, just by setting
that on top of my project. Now the edges of this handle are actually pretty sharp, we're
going to come back later and sand those down, you can also router them at this point, just
put a small round over router bit to it, and that'll make it nice and smooth.