Tip:
Highlight text to annotate it
X
Okay now we've frapped the board, we've filled the board, the fill is dry and we sand it
flush and now we're going to go ahead and laminate some fiberglass on there. So what
I do for an area like that, come over here and get my scissors. You definitely going
to want sharp scissors for this, but just take a big piece of fiberglass and give it
a nice cut, and then we'll just go over and we'll just cut it to fit that area where we
need a patch. So what I like to do is I usually apply two pieces of fiberglass. One will be
around the diameter of the ding, pretty fit just a little bit outside of where you feel.
And you can just free hand it nothing needs to be perfect. Just like that. And then after
that what we'll do is we'll add the second layer but I usually like at least an inch,
an inch and a half outside of that first layer just so we can actually feather in the sanding
afterwards. So again, just something free hand, just like that, that's perfect. So two
layers of the fiberglass, we're going to put our gloves on and we'll have some laminating
resin and we go ahead and laminate some resin on there.