Tip:
Highlight text to annotate it
X
Now the next step in adjusting our door is we have had to replace the bolts in the hinge
and what happened is the screws. Since this turns out to be a hollow core door the screws
just aren't holding at all. So what we have to do to effect that repair is we are going
to get some little nuts and bolts and we are going to run these bolts all the way through
the door, through these hinges and that should hold the door in place. So I think it is something
like this and then we put the nut on the back side. We will go ahead and tighten these up
and then the hinge will be held more firmly in place. Now I'm going to punch through,
whoops I wasn't supposed to do that, I already had that drilled out. Now that didn't go straight
either did it? Now we are going to go through at this angle, ow, o'kay and that went through
properly. So now we are going to put another bolt through here on the other side, now that's
going to be pretty strong I think, it was a pretty big bolt. We are going to put one
more on this door and then one more on the other one then we will be ready to hang the
door.