Tip:
Highlight text to annotate it
X
Measure the skate blades width by using the hollow and blade thickness tool
Turn the scale *** to the same width as your blade
Measure the area of your skate that you would like to profile
Always profile at least 60% of your skate
Clamps the skate
Choose and mount the template of your choice
Push the "Profile" button once and a light will start to blink
Now press the Sharp button
and the sledge will start to move without the grinding wheel spinning
Adjust the guide-roll's height
When the guide roll is moving the grinding wheel won't profile the blade
And when it's not moving it will profiling
Put marks on the template when you're satisfied with your settings
These markings will show you where to profile the other state in your pair
To make the profiling faster, you have the opportunity to choose which area of
the skate you would like to profile
One light and the machine will sharpen between "Profiling dot" one and one
Two lights and the machine will sharpen between "Profiling dot" two and two
Finally three lights and it will sharpen between "Profiling dot" three and three
Choose the profiling dot suited for your skate and press sharp
When using the "Profiling dots", one push on the "Sharp" button
equals 5 cycles
You may also increase the wheel pressure to speed up the profiling process
As said earlier, as long as the guide-roll doesn't move
it profiles the skate
When you reached a smaller profiling area like this. And would like to hurry
up the profiling process you have the opportunity to turn the sledge manually
Just press the "Sharp" button
each time you would like to turn the sledge
When the guide-roll is touching the whole template the profiling procedure
is finished
Before skating with your newly profiled skates please re-dress the grinding wheel
and sharpen it to smoothing out the blade
See "AS2001 Dressing" and "AS2001 Sharpening"