Tip:
Highlight text to annotate it
X
Keeping attention on the presentation in a meeting can be a challenge when attendees
are preoccupied with getting their feet untangled from the unmanaged cords and cables under
the table. Under table cable management organizes and retains cords and cables to keep the space
underfoot while allowing ready access to services for technology upgrades. It's easy to order,
install and maintain. Just order 1 part number, UTCM5, and you'll get everything you need
for a five foot installation. Under table cable management installs in just 6 simple
steps. You'll need a drill, a screwdriver, and tape measure. Under table cable management
comes in 5 foot lengths to accommodate most table lengths, however, a basic mounting rail
can be easily cut to length on site. Mount the hinge rail by first marking the rail six
inches from the end and every 16 inches from the previous mark to locate where to install
the mounting screws. Then, hold the rail in place to pre-drill pilot holes and screw the
rail in place under the table in the desired position. Install the base by snapping the
flat edge of the base mount into the rail slot. Locate and mount latches 16 inches on
center in the same locations as the screws in the hinge rail. Attach the mounting clip
with the screw on the inside and the outside of the clip. Load and organize cables in the
base, separating power cords from data and A/V cables if desired. Finalize installation
by rotating the base to snap into the clips to close the system. If a cable egress is
desired, cut the bases needed, creating a gap for cable to exit. For future modifications,
simply release the base by pushing on the clips. When you need to get cables out of
the way and get on with your important meeting agenda, request Legrand/Wiremold Under Table
Cable Management.