Tip:
Highlight text to annotate it
X
IGO-F Rebuildable Dripping & Tank Atomizer from Gold Drive
Welcome to the video where we will take a closer look
at the rebuildable atomizer
which can be used either for direct dripping
or with a small 1ml tank. It's IGO-F.
IGO-F is delivered in a paper box
containing a piece of wick and kanthal,
sealing o-rings, center pin sealing,
extra filling grub screw,
and an Allen key fitting this little screw.
IGO-F has a 510 thread
is stainless steel,
and you need to prepare it for the first use yourself
with the accessories included.
I have prepared a bow here
to illustrate how to do it.
You can see the coil and two wicks,
the ends of wicks are foiled
to make it easier to put them through the holes
– we will yet see how useful this is.
The lower part of the atomizer is threaded
and can be removed, so this makes its little 1ml tank.
And here you can see the filling grub screw
which of course can be removed from the outside
and here...
ups ...you fill it in with the needle from the bottom,
put the grub screw back and that´s it.
Now, we will see how good I am… If I can put it back…
Ok, good.
So, we have seen how to fill this atomizer from its bottom
and now we will see how to work with the wicks.
So, one hole, put it through,
and the same with the other end…
Super.
Bingo.
Now, this is feeding from the bottom.
So, how much will we need?
I will cut it off here and we can screw it in.
Here are cross threads
and the coil is attached right under those screws.
The upper cap makes a one piece including a drip
so we will not change the drip,
and there is also an air hole here.
We will put the bow up here
and place the air hole right against the coil like this.
And we are ready.
Here, we have just the EGO thread cover left,
in case we use and EGO battery or anything with the outside EGO thread.
The weight of the whole atomizer including the cover
is 32,5 grams.
Length without the cover including the drip tip 47 mm,
diameter 14,5 mm,
and with the thread cover the total length is 57 mm.
So, this is IGO-F,
now ready for dripping and vaping.
My setup has about 1,7 ohm so for mechanical Corolla just allright.
Maybe just one thing to be careful about
– when you screw the little tank together,
with the central contact inside,
be careful that you do not squeeze the wicks in between like I did
because then they insulate and there is no contact,
so I had to cut the wicks a little bit more,
put them inside nicely and then screw the two parts together again.
Then the central contact for electricity works well and you can vape.
If you put inside 10 drops it will bubble
and go out over the grub screw, I would say 7 drops are ideal.
This is IGO-F,
a small tank atomizer, suitable also for direct dripping.
Have a nice time and see you again.
Bye.