Tip:
Highlight text to annotate it
X
Today, were going to review part number 23-468. This is the Dexter 10-inch Nev-R Adjust Electric
Brake Assembly for the left hand side. This Dexter assembly is a 10-inch by 2-1/4-inch
left hand brake assembly and a way to measure that is if you go across the diameter of the
of the shoes it should be 10 inches, and then if you measure the width it would be 2-1/4
inches. This assembly when paired with a right hand side assembly will give you a 3500-pound
weight capacity for the pair. This does use 10-inch hub and drum assemblies and this brake
assembly does include the mounting studs. The nuts and washers would have to be purchased
separately and Ill give you the dimension of that mounting studs.
They are on center to center 2-7/8 inches both ways so you want to check your brake
mounting *** on your trailer axle. Make sure the measurement between the holes is
2-7/8 inches. And this is an electric brake assembly so its not used for any inaudible
0:01:18.5 applications and it does have two wire feeds. And basically, one of the feeds
would be for the brake feed the other would be a ground wire and it wouldnt matter which
wire is used for which feed. And I did mention this is a Nev-R Adjust Brake Assembly and,
basically, what that means is once it's installed initially, youll do an initial adjustment
to the brakes and then after that every time you use the brakes it will automatically adjust
the
brakes for you.