Tip:
Highlight text to annotate it
X
have you ever wondered just how easy three intellect products are to apply
if you can just remember these three easy steps
cut and apply well then it's a snap
first you need to start with the clean dry surface
in order to make sure that your surface is cleaned simply is and it's a problem
kaha
or rubbing alcohol which is available at any pharmacy and wipe with a clean
cotton cloth
this will allow you to remove any debris or oil that may be hiding on the surface
don't forget to let it dry thoroughly before you apply any three and a lot
product
now is you wait for it to dry simply cut the three and a lot by using any pair of
regular scissors
remember
four square inches per pound of holding weight is suggested as a starting point
to determine how much three and a lot product to using your application
healy find however that you can use considerably less
depending on the application
last
simply lift the coroner edge of the liner in peel back
may be sure to touch the edge of the three and a lot product to the surface
of the substrate
and press down along the entire length of your piece trying to reduce the
trapped in a very powerful
press firmly into place
rolled on if you can with the roller such as this
which is available at most hardware stores
you should let the till after well first debt so that the adhesive can building
adhesion for at least one hour before using
however seventy two hours is preferred
now you are ready just snap it in the place
brooke detailed information on how to apply three and do a lot gold three m's
website at three ambassadors dot com