Tip:
Highlight text to annotate it
X
This is how to refill HP 128A color cartridges.
An original cartridge set costs upwards of $275! Let me show you how to refill your cartridges
and cut that cost by 75%!
This is a Toner Holemaking Tool. Use this tool to easily pierce into a cartridge without
the risk of plastic bits damaging the internal components.
Step 1. Peel back the cartridge label.
Step 2. Pierce a hole into the toner compartment
Step 3. Empty out all the old toner. This is very important because if you have two
different toners in the cartridge at the same time, your print quality will be compromised.
Here is a bottle of InkOwl’s high-quality black toner for HP Color LaserJet.
Step 4. Pour the whole bottle right into the cartridge.
Step 5. Seal the fill hole with aluminum tape provided with all InkOwl toner kits.
Step 6. Pierce a hole into the excess toner compartment.
Step 7. Empty out all the excess toner. If you don’t empty this compartment, you’ll
start seeing streaks on your printouts.
Step 8. Seal the hole with tape.
We will now replace the cartridge’s smart chip. Replacement chips are always included
in our toner kits when needed.
Step 9. Cut the plastic tabs that hold the chip in place.
Step 10. Poke the chip with a knife and then pop it out of its slot.
Step 11. Slide in the new chip.
Congratulations, your cartridge is ready to be installed! By refilling all four cartridges,
you’ll save yourself $200 and throw four less cartridges into the landfill.
Take a moment, think green, think refilling, think INKOWL!