Tip:
Highlight text to annotate it
X
[intro music}
[Title frame] Polymer Clay DREAM Machine - How to clean the roller blades in 2 minutes or
less...Really!
Presented by PolymerClayer.com and Nancy Ulrich. A helpful video posted on the Polymer Clay
Dream Machine review page. http://www.polymerclayer.com/polymer-clay-dream-machine.html
[caption] You will need a clean towel, a small adjustable wrench and some baby wipes.
Do not use the included mini-wrench for loosening and tightening your pasta machine screw heads.
You will want to tighten them down firmly and quite frankly that tool isn't up to the
job. Get a small wrench from the garage.
Get a towel. Lay your machine upon it on its side, front side up. The crank handle hole
will be on the right.
Turn counter-clockwise to loosen the screw heads holding the polymer clay pasta machine
blades
Place the screw heads where they won't roll off the table. And also put them so that their
position helps you remember where they need to go when you reassemble the blades.
After you remove the 3rd screwhead, the blade and blade support will fall off. Reach between
the base and the rollers and pick them up for cleaning.
Separate the support bar from the blade and set it aside carefully.
Grab a baby wipe and clean both sides of the blade and support bar.
When they're both clean, re-assemble by aligning the blade holes over the screw heads on the
support bar. Fit the assembly into the holes on the machine. Replace the screw heads and
tighten them clock-wise with the wrench. Make it firm, but don't strip the screws.
Flip the machine over and repeat to clean the back blade and support bar.
Once you've cleaned the back blade of the Dream machine, place it back on its base.
Insert the handle and wipe down the guides and rollers.
Actually it took a minute longer to explain how to clean your ArtWay Polymer Clay Dream
Machine than it will take you to do it.
Have questions? For more polymer clay tips and tricks visit PolymerClayer.com.