Tip:
Highlight text to annotate it
X
Alright, today on this 2012 Dodge Journey were going to install the Rhino Roof Rack,
part number SXB4-SILV. Our vehicle is already equipped with the factory roof rack so were
going to add our Rhino Rack to the top of that. Very simple to install and were going
to start off with our Rhino Rack already reassembled according to the instruction, so we'll just
place it on top of the factory roof rack. Ok, next well go ahead and make sure that
the crossbar is square with the factory roof rack so we'll measure from the edge on the
factory roof rack to the leading edge of the Rhino Rack. In this case were going to use
a measurement of 10 inches. Ok, now well go ahead and move on to the second crossbar.
Well repeat same steps before. However, we'll measure from the center of the first crossbar
to the center of the second crossbar. And that measurement were going to use is 28 inches.
Now these measurements can vary according to the different type of accessories you will
put on top of this. Well make sure that the crossbars are even from left to right and
then we can go ahead and tighten them down with the included tool.