Tip:
Highlight text to annotate it
X
Today on this 2006 Nissan Murano we are going to install part number C56105 from Curt, their
T connector wiring kit. The first thing we need to do is get access to the inside of
the vehicle so we are going to have to open up the hatch and we are going to remove some
interior panels to get to the wire harness. This compartment we have to move also so we
have to remove these two bolts and that will allow us to take it apart. In order to remove
this compartment we also have to loosen up the carpeting on the side here too. We are
just going to pop up this cap right here and then we will remove the tie down hook. Now
we have got our driver side done, now we will go over to the passenger side and repeat the
same process. 00:50 At this point we can start installing the
wire harness. We are going to start with the yellow wire and that is going to go to the
driver side and we are going to look for the harness basically that goes right into the
tail light and that is going to be this one right here with the foam tape around it. We
are going to simply push down the button right here and some times they are kind of hard
to push down so take a small screwdriver and push down on it and simply plug in the harness.
Take the white wire and ground it to one of these assembly bolts right here. I think what
we will also do is unbolt this little bracket right here and just slip the yellow wire behind
it
that way
we do not have to worry about interfering with the latch. 01:30