Tip:
Highlight text to annotate it
X
Today on our 2003 Ford F250 well be installing as well as going over the operation of the
Superwinch Talon Series 12.5 I Winch part number SW1612210. The Superwinch can be installed permanently in
a fix mounted location and you will not need to change the wiring on the winch. Now for
our application today well be showing you how to use it with the Curt Trailer Hitch
Electric Winch Mount Plate as well as the Superwinch Electric Wiring Harnesses for both
the front and the rear of the vehicle which allows us to use the Curt Trailer Hitch Electric
Winch Mount Plate which is part number C31010 as well as the handles for the Winch Mount
Plate which are part number C31005. You may also notice some of the wires that come out
of the top of the winch are a little bit different. Thats because this winch has been wired to
accommodate the Front Vehicle Electric Winch Wiring Harness which is part number SW2007
as well at it also works with the Rear or the Trailer and Vehicle Electric Winch Wiring
Kit from Superwinch part number SW2008. In both of those kits you will actually remove
the ground and the red or the positive wire from the winch and youll replace them with
parts from their kit. Were going to need to remove the cover that covers up the center
solenoid section. Now depending on your winch the removal of the cover to get the positive
side off might be a little bit different than ours, but for ours we need to remove a couple
bolts here that hold the cover on and gain access to the bolt that holds the red wire
or the positive wire on the solenoid side. Next well go ahead and fish the red wire out
of the grommet here. Once we pull the red wire out well go ahead and fish our new positive
side through the grommet into the area where well be making
our connection.