Tip:
Highlight text to annotate it
X
Assembly instructions for Trim Hoop 2MS. [There are a total of 8 sections]
Locate the blue section with the button, it will later connect with the hole inside the purple section
Notice that it has a button and will later be used to lock into the last section which will be the purple section
Please note the purple section has a hole which connects to the button of the blue section. [Purple will be the last connector]
Start with the blue section. Insert the stem of a non-purple section into the hollow end of the blue section.
*Important: The flat grooved part on the stem of the section must slide along the bump inside the hollow end of the blue section. Once inserted, twist.
Continue connecting the remaining sections. Pay special attention to matching the bump inside the section to the grooved line of the stem part.
Make sure you twist enough to feel the sections lock into place. If the sections of the hoop do not line up evenly then continue to twist the sections until they do.
Careful not to over-twist. If the sections lay flat on a table surface then they are correctly attached.
Finally, the last two sections will be the blue and purple sections.
Hold down the button on the blue section before entering it into the hollow end of the purple section.
If you are unsure if the button is locked, you can gently tug on the sections to make sure the button is correctly locked.
Your hoop is now assembled and ready for use