Tip:
Highlight text to annotate it
X
Ok, so now we have our chair back together again, we have repaired all of our broken
dowels, cleaned all of our joints, we have applied glue in the hole on all the dowel
parts. We have put everything back together gently by hand and tapped it together. You
just want to use a little bit of force to bring all the joints back together, once you
get the back of the chair ready, lay it on it's face you are going to apply pressure
with clamps, what this does is brings the joints completely together and gets them extra
tight. So again, we don't want to crush the chair, we want to be centered right on the
base of the rail, put fairly nice tight pressure then we are going to rotate the chair over,
and we are going to put pressure from the top rail down, this will tighten these joints here, we have
these joints tight, one more clamp to get the other one.
Again this snug pressure you don't want to crush it, cause you could break this piece
if you get too much pressure. Once you get that clamped up, just set it aside for now.
Let that glue do its work and dry up and we'll start up on the other part of the chair.