Tip:
Highlight text to annotate it
X
Today on our 2010 Chevrolet Equinox we'll be installing the Trailer Mate custom tail
light wiring kit for towed vehicles, part number TM780072. To begin our install we'll
first start at the rear of the vehicle where we'll open up the rear hatch. Then we'll
need to remove both tail light assemblies. To remove the tail light assemblies we'll
first remove the two fastener covers on each side. Using a small bladed screwdriver we
can go ahead and pop them out of the way and sit them aside for re-installation.
Then we'll go ahead and remove the fasteners. Next we'll need
to remove
the tail light assembly
being
careful as we
pop it out of its
position not to break the alignment
tabs underneath.