Tip:
Highlight text to annotate it
X
Hi! I am Drew Fenn professional home inspector. I am here for Expertvillage.com. Today, we
are going to install a shower head and I will show you how and the video is produced by
Black Dog Video. You can visit blackdogvideo.biz on the Internet. We are going to remove the
existing shower head. Now, this one is loose enough I can do with by hand, but if its too
tight you are going to need a wrench to get it off. If you have either a pipe wrench or
some channel locks you can use that to take it off, but remember counter clockwise loosens
things, so if you had to use the channel locks, use grab it on squeeze tightly and go around.
You don’t want to slip too much because it could take the finish off the shower head
if you are going to use it again. The pipe wrench you adjust the height this way, you
want so it clamps on, there is still a little bit of gap here then when you tighten it,
it is going to tighten up and loosen it. So, that is loose enough that we can take it off.
Now, what we want to do is after we take it off we want to clean off the residual Teflon
tape that is on there. You can usually get most of it off your hands, if you need to
you could use a wire brush to get it really cleaner, actually even a toothbrush could
work to clean it off if you don’t have a wire brush.