Tip:
Highlight text to annotate it
X
Today we are going to show you an American Flag Waving 2-Inch Hitch Receiver Cover, from
Alfred. And this is part number 034092100201. As you can see here, it depicts an American
flag in a waving position. And this fits only 2-inch receiver hitches. And it is constructed
out of alloy material with an enamel inlay into the etching here to provide the colors.
On the backside here, you can see the actual alloy material that it is made out of. It
also comes with a gasket. What that does, it helps seal up the hitch tube cover and
also provides a little bit of friction or something to press against for the wire forms
as they are installed into the receiver hitch itself. And the wire forms themselves have
two different lengths to facilitate installing a hitch cover, because sometimes a hitch pin
in the end of the hitch itself has varying lengths, depending on that manufacturer. And
on the tabs here, you can see that the pins have different heights, like say this one
is towards the end and this one is towards the bottom. Again, it gives you better adjustment
to make a proper fit on your hitch. We will go ahead and install it on a 2-inch
receiver hitch and show you what it looks like. We will show you how it gets installed.
The wire form goes in and it touches the corners of the hitch and then press in and then slide
your pin through. As you can see here, we use a 2-inch receiver pin, a standard one.
Also, you can use a locking hitch pin too. Alright, and that covers our review of part
number 034092100201.