Tip:
Highlight text to annotate it
X
Okay, so here we have our board, it's laminated, it's hot coated, it's dry and this board is
shiny, which is a gloss and polish. So we have one more step on this one, which is we're
going to sand down that patch, we're just going to feather it in and kind of get it
all shiny and flat and then we'll put a nice thin hot coat on it, which is called the gloss
coat which after that we'll polish out. So, let's grab the machine and the 50 grit which
is what I use. At home you probably want to use a 100 grit or an 80 grit which is a little
bit less of a grit sandpaper. That way you can't really burn through all that fiberglass.
I have really good touch so I'll just feather it in real nicely. What I'll do is, you'll
see me start on the outside and just kind of flatten it out by working around the fiberglass
taking the edges in. So let's do that. So that now that we've used the machine for the
real, you know, real work, we'll just go ahead and flatten it out by hand and just kind of
get the feel for it, you know, just make sure it's real flat. Any high spots, kind of knock
it down and that should do. So let's blow it off and I'll show you what we have here.
So now we have the two patches, the inside smaller patch is right here obviously. The
outside patch is right here and then this is the real strong point of the surfboard
that was there originally. Now if you could see, you could see the hints of the fiberglass,
everything is real feathered in. Most importantly, there's a lot of fiberglass right here at
the repair feathered in back to the board and that's going to give you the real strong
bond, where there's no weak point. A lot of people will sand too much outside here and
put a little patch right here, which will make this strong, but everything real weak
right here. So what we've done is made it a big patch, get it all feathered in and now
we'll go over back to our hot coat resin and then we'll put a nice gloss coat on it.