Tip:
Highlight text to annotate it
X
Hello I'm Mark from expert village. In this segment we'll show you how to install a hose
part two. We got that one tight, we'll come up and tighten this other clamp. This is the
one that's not quite so accessible as the other one. First we need to slide the clamp
back up into it's proper position.
Sometimes if it's in a real bad position, gravity will have it's way. You might want
to put a little piece of tape on the clamp to kind of hold it on the hose where you want
it to be and it could prevent you a little bit of frustration and anxiety trying to get
it back in that position after it slid down. In this case I just simply can't get it through
the clearance, so I'm gonna disconnect the hose, slide the clamp down and reconnect the
hose while holding the clamp in position. Once I've accomplished that, then I simply
have to tighten down the clamp. Once again ensuring to put it into proper position so
it gets right on the base of the lip on the ***.
Times like these you'll find it may be handy to have an extra hand to kind of hold the
electrical connectors out of the way, hold the clamp in place, and tighten the screwdriver.
Just remember it can be frustrating at times, be patient, don't lose your temper. Ok we've got them tightened down. I'm just
going to quickly check them. Try and twist them with my hand and try and tug on them
a little bit, make sure they're tight. So watch our next segment on a helpful hint or
tip that might save you some diagnostics time or assist you in verifying correct installation
of the hose.