Tip:
Highlight text to annotate it
X
bjbj MagnuM Control Board Operation Welcome to control board operation for the MagnuM
series of products. To start the unit, simply press the ON button. This will begin the start
up sequence that will begin with a 30 second diagnostic cycle indicated by the blinking
of the on and off light. After the cycle and once the vacuum has been established, the
auger light will briefly illuminate indicating that it is operating and sending fuel to the
fuel pot. If at any point vacuum is lost or cannot be established during the startup sequence,
the sensor will fault and will show a blinking number 2 light on the control boards temperature
setting. To reset the error, press and hold the ON button. As the startup procedure continues
and the flame in the pot is established, the proof of fire sensor will engage as indicated
by top light. If the proof of fire heat sensor looses temperature, it will fault and cause
the number 3 light to blink. To reset the error, press the ON button. The unit is now
fully operational and the desired heat setting can be set by pressing the heat level button.
Shut Down: To enter into the shut down sequence, simply press the ON/OFF button. [Content_Types].xml
Iw}, $yi} _rels/.rels theme/theme/themeManager.xml sQ}# theme/theme/theme1.xml w toc'v )I`n 3Vq%'#q
:\TZaG L+M2 e\O* $*c? )6-r IqbJ#x ,AGm T[XF64 E)`# R>QD =(K& =al- 4vfa 0%M0 theme/theme/_rels/themeManager.xml.rels
6?$Q K(M&$R(.1 [Content_Types].xmlPK _rels/.relsPK theme/theme/themeManager.xmlPK theme/theme/theme1.xmlPK
theme/theme/_rels/themeManager.xml.relsPK
MagnuM Control Board Operation aesoffice Normal Beth Microsoft
Office Word MagnuM Control Board Operation Title Microsoft Office Word 97-2003 Document
MSWordDoc Word.Document.8