Tip:
Highlight text to annotate it
X
Ok, now it's time to put the base that we made, I mean the shaft that we made before
on the smaller of the two bases. I've put it on the base, kind of centered it there
and laid down two pieces of tape here, so that I know exactly where to put this back,
after we take it off. We've marked with the pencil, just inside the tape about an eighth
of an inch, I made two little pencil marks and took my small drill, and drill a hole
there, and a little hole there, that's so we can see from the bottom where our screws
are going to go in. Next, I take the shaft, set it on there referenced to the tape, and
I've placed two small nails at an angle, and holding the shaft down, I'm just going to
pop them in. And, fool around with it a little bit to hold this base still.
That's going to hold the shaft onto the base.