Tip:
Highlight text to annotate it
X
Today we are going to install part number 41931 from Draw-Tite, and we are going to
install this hitch on a 2006 Ford F-250 Super Duty. We are looking at the passengers side
frame rail here, and the hitch is going to get attached at this hole here, here, here
and here. And you can tell by the whole area that the original factory hitch was on there
already so we already took that off. The hitch is going to attach to the same place as the
factory hitch did. This one will be a lot heavier hitch. And it will be identical on
both sides. The factory wiring we took and just tucked it out of the way for now during
our install. We will go ahead and reinstall that after the hitch is done.
Next we will go ahead and start installing our hardware. Each set of holes will get one
of these plates. We in our bolt, and we do that for the remaining three sets of holes.
At this point we can go ahead and start installing our hitch. We have the hitch hung by a couple
of the nuts, and now we will go ahead and install the rest of our hardware. And
we have got our conical-tooth washer and our nut. And it is really going to be the same
all the way around. All right, at this point we can give the bolts their final torque,
as specified in the instructions.