Tip:
Highlight text to annotate it
X
Hi i'm Jewels and welcome to in the tank with Korky. Today I will be your personal guide
in showing you how to install the Korky Ultra Water Saver Flapper. As always with the Korky
the installation is easy and this flapper will take you less than ten minutes to install.
The first step is to shut off the water supply to your toilet, then flush your toilet. Then
mark the water level with a pencil and drain the excess water. Remove the old flapper and
install the Korky Ultra Water Saver Flapper. Attach the flapper ears to the tabs on the
flush valve. Then attach the flapper chain to the flush lever with minimal slack. Turn
the water supply on and let the tank fill completely. Now, turn off the water and flush.
If the water level drops within a half inch of the pencil mark your installation is complete.
If not, rotate the white band to the open position ... and turn your water supply on
and let your tank fill completely. Now, turn your water supply off and flush. If the water
supply is still not within a half inch of the pencil mark the Korky Ultra Water Saver
Flapper allows you to fine tune your flapper for optimal control. Adjust the dial to align
with the next lowest number using the arrow. Repeat the process by turning the water supply
on and let your tank fill completely. Then turn your water supply off and flush. The
dial can be further adjusted until the water level is within a half inch of the pencil
mark. For the most popular toilet settings, see the back of the flapper card. If you need
further assistance with the installation of the Korky Ultra Water Saver Flapper, please
visit our website, or contact us at 1-800-LAVELLE