Tip:
Highlight text to annotate it
X
Alright. We're getting very close here to finishing up our piece right now. So, let's
have a look at it. As you can see, we've already modified this and added some noise here. Let's
go ahead and add a little texture to that. Let's go to "Filter, Texture, Texturizer,"
like so. And we're also going to use our sandstone here. We're going to leave it at the same
settings we had before--200, 20, and, of course, from the top. We're going to go ahead and
hit "Ok," like so. Mmm, it looks like it might be a bit much. Let's Command-Z, Control-Z,
that. Let's go to "Filter." Let's do that again. Let's go to "Texturizer." This time,
let's zoom in on this just a little bit so I can see what I'm doing. Let's take it down.
There we go. Eighty-five doesn't look so bad. And we'll take my relief down just a little
bit more. Actually, not too much more. There we go. Ok. So, eighty-five and fourteen look
pretty good. There we go. It's not as hard as it was before. Now what we're going to
do is, we're going to go ahead and "Bevel and Emboss" this. So, we double-click on our
layer here. And, let's click on our "Bevel and Emboss," like so. And, let's see. We're
going to leave our blend mode; well, let's click on our layer first.