Tip:
Highlight text to annotate it
X
In this instructional video you'll see how to install the VintageView FCF with WS series
wine racks. To begin, measure the height from the top of your finished floor to ceiling.
Each FCF contains two sections that are 5" tall. So subtract 5" from your floor to
ceiling measurement and mark the resulting dimension on each leg of one section.
Next, cut the frame that you've marked using a hacksaw or other metal cutting saw. Take
care to keep the cut square. Remove any burse from the cut end with a metal file. Insert
the plastic couplers into the open end of the frame by pressing them into place or gently
tapping them in with a mallet. Align the two sections of the frame and assemble
by pressing together or gently tapping with a mallet. Remove the end plug from WS series
rack and replace with the provided couplers setting the racks in the desired position
on the face of the FCF. With the metal wine racks in place, take note
of the mounting hole locations to ensure that one rack will span the joint in the FCF. Secure
the racks to the face of the frame with the provided self-drilling screws.
After removing the unplug from the bottom of the rack, slide the next section in place
over the coupler and secure. With the VintageView metal wine racks California secured in place
on one side, flip the frame over and attach the racks or FCF backers to the other side
of the frame. Stand the assembled unit in place taking care
to maintain a 13" standard spacing from left edge to left edge. Secure the frame in
place at the top and bottom using the appropriate fasteners for your floor and ceiling surfaces.
Snap the provided mounting hole covers in place to finish your installation. Load the
wine, stand back, and enjoy the VintageView metal wine racks.