Tip:
Highlight text to annotate it
X
Hi, it’s Steve from PartSelect. Today we’re going to show you how to change the leveling
leg on your dryer. It’s a really easy job; all we’re going to need is either an adjustable
wrench or a pair of slip joint pliers. Let me show you how we do it.
Now to change the leveling leg on your dryer, if it’s just one of the front legs then
really all we need to do is to make sure that there’s enough flex in your vent to be able
to tilt the dryer back a little bit; if it is a rear leg we need to pull that dryer out,
disconnect the vent and the procedure will be the same.
Simply tilt the dryer up, just put something under it to hold it in place, make sure it’s
stable, and then with either a pair of slip joint pliers or an adjustable we’ll locate
the leg and unthread from the base of the machine. Once you’ve unthreaded it just
remove it.
Start the new one in the opening; just give it a couple turns by hand utill the thread
starts. And again while it’s supported, simply tighten it up. When you think you’re
getting close to where it should be lower the dryer back down onto the floor and then
make sure there’s no rock from side to side or corner to corner. And if so just adjust
it accordingly up or down till you take all the movement out. And our repair is complete.
Told you that was an easy job. Thanks for watching, and good luck with your repair.