Tip:
Highlight text to annotate it
X
Today on our 2010 Chevy Equinox well be installing the Curt hitch, part number 13591. This is
what our hitch will look once its installed. Next well go ahead and give you a couple of
measurements to assist you when selecting accessories for your new hitch. From the center
of the hitch pin hole to the outer most edge of the bumper is 4 inches. From the top of
the receiver tube to the ground is 14 inches. This will assist you when selecting accessories
such as a draw bar, a bike rack, or a cargo carrier.
Now lets go ahead with installation. First well need to remove the rear fascia panel.
To remove the panel you can use a flat bladed screwdriver or a trim panel tool. Next well
go ahead and point out the six attachment points. For this application each attachment
point will be a weld nut built into the frame or cross member by
the manufacturer.